remote.jpg

R.F. Hopping code remote controle for BANDIT

LED indication
of transmission

Technical specs. pocket transmitter:

EMC compliant, 2-channel, RF. transmitter

Housing:
Battery:
Output:
Operating temp.:
Range:

ABS enclosure, splash proof, dim: 66 x 34 x 16 mm.
12V type GP23A, supplied.
AM radio freq. 433.92 Mhz at 10 mW.
0 - 60° Celsius.
upto 80 metres.

Connector to BANDIT PCB

Holes for threaded
mounting pins

Blue antenna wire

About the company
Fog security introduction Products
Loading software
Loading manuals
Legal stuff
Distributors
Publications
End user prices

Technical specs. receiver:

FCC compliant, 2 channel, RF Rx / decoder receiver.

Housing:

Receiver:
Electronics:
Transmitters:

ABS enclosure fot integration in a BANDIT device.
dim: 79 x 51 x 12 mm + 6 core connection cable.
superheterodyne Rx 433.92 Mhz at -106dBM.
EMC full protected Keeloq protocol MCU.
decodes and learns max. 50 unique transmitters.

Learn tact
switch

Red Learn LED

Integration into a BANDIT device:

	-		Open the BANDIT back compartiment, remove the battery and mount the receiver over the two M3 thread pins at the right upper corner of the back compartiment.
	-		To fix the receiver, screw on the two supplied white plastic M3 nuts.
	-		Guide the cable byside the plastic battery holder and connect the female 5-pin connector into the brown 5-pin male connector on the BANDIT PCB (connector directio !!).
	-		BANDIT will automatically recognize the remote control (see device "installer manual").
	-		Elongate the blue antenna wire so that the antenna wire hangs out about 17 cm. The insulated "hot" end of the antenna wire should be kept as far away as possible from the steel housing of the BANDIT.

Learning a transmitter:

	1.		Briefly press the Learn tact switch.
	2.		Red Learn LED will illuminate.
	3.		Depress the transmitter channel once, Red Learn LED will extinguish.
	4.		Depress the transmitter channel again, Red Learn LED will flash for approx. 10 s.
	5.		Wait for Red Learn LED to stop flashing.
	6.		The selected channel will now operate Bandit.
	7.		Repete from 1 to 6 for the second channel.

Erasing the receiver memory:

Press and hold the Learn tact switch.
The red Learn LED will illuminate for approx.
10 seconds (erases the memory).
As soon the red Learn LED has turned off,
release the Learn tact switch.
The transmitter recognition memory is now
completely erased.